Get a quoteRequest a demonstration

Operating guide

How to use the METClean E

On the METClean E, the operator connects and straps down the DPF and sets the wash using the analogue controls. The machine then runs the wash sequence automatically. Check the operating instructions for your E before setting up the machine or changing the settings. Check the compressor supply separately from the working pressure shown on the machine gauge.

Before you start

For trained operators of the METClean E. You need the power and compressed air connected, the tank full and the machine on level ground, with gloves and safety glasses. If your panel looks different, send MET your model, serial number and a photo of the controls.

Watch the METClean E operating film

METClean E · MET on YouTube · 8 November 2026 · 1 min 40 s

MET’s walkthrough of a DPF clean on the E’s analogue controls: heating the tank, connecting and strapping down the filter, setting the air and the clean time, running the wash and blowing the water out with compressed air.

Nothing loads from YouTube until you press Play; the film then plays in YouTube’s privacy-enhanced mode, and YouTube may store cookies (cookie policy). Watch on YouTube

  1. 0:00 Set up the machine
  2. 0:13 Heat the water tank
  3. 0:29 Check the flow direction and connect the DPF
  4. 0:44 Strap the DPF down
  5. 0:50 Set the air pressure
  6. 0:57 Set the clean time
  7. 1:05 Start the clean
  8. 1:13 Blow the water out
  9. 1:21 Emergency stop
  10. 1:27 Service intervals

Written guide

How do you load a DPF into the METClean E?

Identify the direction of exhaust flow. Fit the adaptor to the outlet, connect it to the braided wash hose and secure the DPF on the platform with the restraint straps. The outlet connection lets the machine wash against the normal exhaust flow.

Written guide

How do you run the wash and clear the remaining water?

Use the heater and timer controls as directed in your model instructions. With the filter secured and the door closed, start the wash. The E runs through prewash, main wash and high-pressure impact. After washing, follow the instructions for the cold-air purge to clear standing water from the DPF.

How much water remains depends on the filter design and its condition, and on your compressor. Follow the drying and refitting instructions for that component. If it still holds water, check the procedure with MET.

Operating instructions

How to use the METClean E

MET’s step-by-step operating guide for the METClean E’s analogue controls: heating the tank, connecting and strapping a DPF, setting the air and clean time, running the clean and blowing the water out.

Download How to use the METClean E (PDF)PDF, 876 KB, 7 pages

Need help with your machine?

For current contact details and help with your machine, visit METClean support. Have your model, serial number and a photo of the controls to hand.