Get a quoteRequest a demonstration

Operating guide

How to use the METClean V

The van-mounted METClean V has separate controls for wash time and water flow. You set them for the job and the machine runs the wash automatically. Follow the V operating instructions and the installation requirements for your van.

Before you start

For trained operators of the METClean V. You need the protected supply on, compressed air connected and the tank full, with gloves and safety glasses. If your controls look different, send MET your model, serial number and a photo of the controls.

Watch the METClean V operating film

METClean V · MET on YouTube · 8 November 2026 · 1 min 34 s

MET’s walkthrough of a DPF clean on the van-mounted V: connecting and strapping in the filter, checking the air, setting the wash timer and the water flow, starting the wash, the cold-air purge and the emergency stop.

Nothing loads from YouTube until you press Play; the film then plays in YouTube’s privacy-enhanced mode, and YouTube may store cookies (cookie policy). Watch on YouTube

  1. 0:00 Set up the machine
  2. 0:13 Connect the DPF
  3. 0:21 Strap it in and close the door
  4. 0:29 Check the air pressure
  5. 0:37 Set the wash time
  6. 0:44 Set the water flow
  7. 0:51 Start the clean
  8. 1:00 Blow the water out
  9. 1:07 Emergency stop

Written guide

How do you connect and secure the DPF?

Check the exhaust flow direction. Connect the braided wash hose to the DPF outlet using the correct adaptor. Strap the DPF to the platform and close and secure the door as directed in the V manual.

Written guide

What do the timer and water-flow dial do?

The timer sets the wash duration. The separate variable-frequency drive control sets the water flow. Check the air gauge and set the wash using the instructions for your V. Once started, the machine runs prewash, main wash and high-pressure impact, then stops at the end of the cycle.

Written guide

How do you clear water after the wash?

Use the cold-air purge as shown in the V operating instructions. For tank and sock filter maintenance, use the V instructions and plan the work at your base or a site with an approved waste route.

Operating instructions

How to use the METClean V

MET’s step-by-step operating guide for the van-mounted METClean V: connecting and strapping a DPF, checking the air, setting the wash timer and water flow, running the clean and the cold-air purge, and changing the sock filter.

Download How to use the METClean V (PDF)PDF, 1.6 MB, 7 pages

Need help with your machine?

For current contact details and help with your machine, visit METClean support. Have your model, serial number and a photo of the controls to hand.